FaxBack NET SatisFAXtion 8.6 - Manual - Manual (Page 197)

4 – Appendices NET SatisFAXtion 8.6 Manual 197
30008 Session not found. Error type: NON_RETRYABLE .
30017 Invalid password: Password is incorrect for configured account.
Error type: NON_RETRYABLE .
30018 Account login refused: Multiple clients sharing same account. Only
one client can be logged into this account at a time. Error type:
NON_RETRYABLE .
30028 No reply from por t ser ver: Server did not respond. Error type:
RETRYABLE .
30029 Unable to contact ser ver. Error type: RETRYABLE .
30051 Server shutting down or disabled. Error type: RETRYABLE .
30080 The por t ser ver is busy. Error type: BUSY .
30081 The por t ser ver is busy. Error type: BUSY .
30082 The por t ser ver is busy. Error type: BUSY .
30083 The por t ser ver is busy. Error type: BUSY .
30084 The por t ser ver is busy. Error type: BUSY .
30085 The por t ser ver is busy. Error type: BUSY .
30086 The por t ser ver is busy. Error type: BUSY .
30087 The por t ser ver is busy. Error type: BUSY .
30088 The por t ser ver is busy. Error type: BUSY .
30089 The por t ser ver is busy. Error type: BUSY .
4.1.13
30209–30266 Portafax Driver
30209 Timed out waiting for a command: During phase B, the T1 timer
expired while waiting for commands from the sending fax machine. This timer is
35 seconds. Error type:
NON_RETRYABLE .
30210 Remote fax cannot receive: The remote fax device is configured to
not receive faxes. Error type: NON_RETRYABLE .
30211 Can’t agree on bit rate: The modem and the remote unit couldn’t
fall back to or agree upon any bit rate. This is most often caused by poor line
condition. Error type:
NON_RETRYABLE .
30212 Wrong response after training: After sending 1.5 seconds of
training data, the remote unit should have sent a CFR or FTT frame. It sent
something else. Error type:
RETRYABLE .
30213 No FTT or CFR received after 3 DCS/training sequences:
The call connected and T.38 communication was established. The receiving and
sending devices exchanged CSI/DIS and TSI/DCS/training signals. After that,
the receive side is expected to send a CFR (confirmation) or FTT (failure to train),
it did neither. Handshaking was attempted and failed twice more, at which point
IPFax terminated the call. Error type:
RETRYABLE .
30214 No response after sending 3 end of page commands: After
reaching the end of the page, IPFax sends an end-of-page command (MPS) and
expects to receive an acknowledgment (MCF) from the remote device. IPFax did
not receive the MCF and attempted to resend it twice more. After the third