Dynojet 424x: Installation Guide - Manual (Page 97)

E D D Y C U R R E N T B R A K E I N S T A L L A T I O N
Pit Covers
Version 7 In Ground Model 424x/424xLC 2 Automotive Dynamometer Installation Guide
4-13
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PIT COVERS
Before installing the eddy current brake pit covers, verify all cables have been routed
and you have completed the 4WD dyno installation. Refer to “Cable Routing” on page
3-12 for more information.
You will need the following parts:
• 21217513 Calibration Cover (2)
• 21919101 Foot (6)
• 36561045 Screw, 1/4-20 x 5/8", Pan-Head, Torx (12)
• 36582477 Bolt, 3/8-16 x 1.5", Hex (8)
• 37513200 Anchor, Redhead, 3/8" (8)
• 37518200 Redhead Anchor Installation Tool
• 61319507 Support Leg
• 61329400 Pit Cover, Retarder (2)
• DM150-011-002 Washer, 3/8", Flat (8)
• DM150-019-012 Bolt, 3/8-16 x 1", Hex (8)
1 Install three feet using one 3/8-16 x 1-inch hex bolt each to the pit cover.
2 Install the support leg using one 3/8-16 x 1-inch hex bolt to the pit cover.
3 Install three feet to the remaining pit cover using one 3/8-16 x 1-inch hex bolt
each.
Figure 4-14: Install the Feet and Leg to the Pit Cover
AD446
pit cover
foot
leg