beautypg.com

Record – Dynojet 424x: Installation Guide User Manual

Page 40

background image

In Ground Model 424x/424xLC

2

Automotive Dynamometer Installation Guide

C H A P T E R 3
Unpacking and Inspecting the Dyno

3-4

6

Remove the crate braces that support the top portion of the crate.

7

Remove the four lag bolts and washers securing the dyno to the crate base using a
9/16-inch socket, open or box end wrench.

8

Remove the drum guards if installed. If the drum guards are not installed, skip to
step #9.
8a

Remove the five screws securing the rear drum guard and set aside.

8b

Remove the rear drum guard and set aside.

8c

Remove the two screws securing the left and right drum guards and set
aside.

8d

Remove the left and right drum guards and set aside.

9

Before removing the dyno from the crate, you will need to install the track
assembly in your dyno room. Refer to the instructions page 3-5 for more
information on installing the track assembly.

#

RECORD

Be sure you record the dynamometer number on the inside cover of this
manual.

Figure 3-1: Remove the Drum Guards

AD394

rear drum guard

dyno number

left/right drum guard

This manual is related to the following products: