Dynojet 424x: Installation Guide - Manual (Page 96)

In Ground Model 424x/424xLC 2 Automotive Dynamometer Installation Guide
C H A P T E R 4
Eddy Current Brake Installation
4-12
I NSTALLING THE T HETA C ONTROLLER
Use the following instructions to install the theta controller to both the stationary and
4WD dynos.
You will need the following parts:
• 21616205 Theta Controller Mounting Bracket (2)
• 36488100 Nut, 3/8-16, Nylock (4)
• 36540647 Screw, 8-32 x 3/8", Pan-Head, Sems, Phil (8)
• 36923100 Washer, 3/8", Flat (4)
• 66411004 Theta Controller (2)
• DM150-019-012 Bolt, 3/8-16 x 1", Hex (4)
1 Secure the theta controller bracket to the eddy current brake using two
3/8-16 x 1-inch bolts, two 3/8-inch flat washers, and two 3/8-inch nylock nuts.
2 Secure the theta controller to the bracket using four 8-32 x 3/8-inch screws.
Figure 4-13: Install the Theta Controller
EB218
mounting bracket
theta controller
theta controller not
visible from this view