beautypg.com

Torque module installation, Installing the torque module – Dynojet 424x: Installation Guide User Manual

Page 100

background image

In Ground Model 424x/424xLC

2

Automotive Dynamometer Installation Guide

C H A P T E R 4
Torque Module Installation

4-16

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

TORQUE MODULE INSTALLATION

This section describes how to install the Torque Module(s), connect the load cell
cable, and install the side and top brake covers.

I

NSTALLING

THE

T

ORQUE

M

ODULE

You will need the following part:

• 66104001

Torque Module

1

Verify the main dyno power is disconnected.

2

Turn off the main power switch on the CPU Module and unplug the power cord.

3

Remove the dust cover from the existing top module.

Figure 4-17: Disconnect Power and Remove the Dust Cover

HS039

dust cover

power cord

input

power switch

This manual is related to the following products:
See also other documents in the category Dynojet Equipment: