Cable routing, Identifying the cables – Dynojet 424x: Installation Guide User Manual
Page 48

In Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C H A P T E R 3
Cable Routing
3-12
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CABLE ROUTING
Use the following instructions to identify and route the cables for dynos with and
without eddy current brakes.
I
DENTIFYING
THE
C
ABLES
cable
brief routing description
A - 25-pin cable
connects to the dyno electronics (P/N 42924250)
B - data acquisition (pickup card) cable, stationary
C - data acquisition (pickup card) cable, 4WD dyno
four wires (red, white, black, shield) and ferrules,
connects to the Breakout board (P/N 66954001,
stationary; P/N 66953001, 4WD)
D - brake signal cable
two wires and ferrules, connects to the Breakout
board (P/N 76950213)
E - air hose, short (16 feet)
connects to the barbed fitting on the air brake can on
the stationary dyno
F - air hose, long (18 feet)
connects to the T fitting on the stationary dyno brake
solenoid
G - 4WD power cable
connects to the power supply (P/N 76952008)
H - hydraulic pump power cable
connects to your 110VAC or 220VAC power outlet
I - dyno movement pendant cable
connects to the dyno movement pendant
(P/N 76953005, cable; P/N 76953004, pendant)
The following cables are used with the eddy current brake(s):
J - load cell cable, stationary dyno
K - load cell cable, 4WD dyno
connects to the torque module on the dyno
electronics (P/N 76950505)
L - theta signal cable, stationary dyno
M - theta signal cable, 4WD dyno
five wires (black, white, red, green, shield) and
ferrules, connects to the Advanced Breakout board
(P/N 76950413)
N - temperature sensor cable, stationary
O - temperature sensor cable, 4WD dyno
five wires (black, white, red, green, shield) and
ferrules, connects to the Advanced Breakout board
(P/N 76950420)
P - theta power cable, stationary dyno
Q - theta power cable, 4WD dyno
connects to your 240V power source (P/N 76950311)
R - controller cable, stationary dyno
S - controller cable, 4WD dyno
connects to the theta controller (P/N 66952003)