Dynojet 424x: Installation Guide - Manual (Page 64)

In Ground Model 424x/424xLC 2 Automotive Dynamometer Installation Guide
C H A P T E R 3
Hydraulic Movement Installation
3-28
4 Using the floor cylinder mount as a template, mark each hole needed to secure
the mount to the floor.
5 Remove the clevis pin, spacers, and floor cylinder mount.
6 Move the hydraulic ram out of the way.
7 Drill the holes marked in step #4.
8 Install the Red Head anchors. Refer to Appendix A for installation instructions.
9 Secure the floor cylinder mount to the floor using two 3/8-16 x 1-inch hex bolts
and two 3/8-inch flat washers.
10 Secure the hydraulic ram to the floor cylinder mount using the clevis pin and two
spacers removed in step #5 and one hairpin cotter.
Figure 3-18: Secure the Floor Cylinder Mount to the Floor
AD345
secure the hydraulic ram to
the floor cylinder mount
use the floor cylinder
mount to mark holes
install the anchors and secure the
floor cylinder mount to the floor