Bridge installation—4wd dyno – Dynojet 424x: Installation Guide User Manual
Page 76

In Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C H A P T E R 3
Bridge Installation—4WD Dyno
3-40
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BRIDGE INSTALLATION—4WD DYNO
This section will walk you through installing the drum guards, runner mounts, runner
assemblies, cover, and runner tie straps.
You will need the following parts:
• 21214701
Runner Tie Strap (2)
• 21214702
Runner Clamp, Short (2)
• 21214705
Runner Tie Slide (2)
• 21216101
Drum Guard, Right
• 21216102
Drum Guard, Left
• 21216103
Drum Guard, Rear
• 21219512
Bridge Cover, 4WD Dyno
• 21514801
Runner Mount, Short (2)
• 36561045
Screw, 1/4-20 x 5/8", PH, Torx, Black (14)
• 36582034
Bolt, 3/8-16 x 1.25", Button-Head, Flange, Allen (3)
• 36582471
Bolt, 3/8-16 x 1.5", Flange-Hex (6)
• 36588071
Bolt, 3/8-16 x 5", Black Oxide (14)
• 36923100
Washer, 3/8", Hardened, Flat, Steel (14)
• 36932100
Washer, 3/8", Splitlock, Steel (14)
• 61319500
Runner Assembly (14)
• DM150-011-004
Nut, 3/8-16, Hex (14)