Bio-Rad Firmware & Software Updates - Manual (Page 38)

MiniOpticon Instruction Manual
27
Real-time Status Tab
The Real-time Status tab (Figure 21) shows real-time PCR data collected at each cycle during
the protocol after the first two plate reads.
TIP: Click the View/Edit Plate button to open the Plate Editor window. During the run, you can
enter more information about the contents of each well in the plate.
Figure 21. The Real-time Status tab displays the data during a run.
Skip the current step in the protocol. If you skip a GOTO step,
the software verifies that you want to skip the entire GOTO
loop and proceed to the next step in the protocol.
Flash the run indicating LED on the MiniOpticon system.
Pause the protocol.
NOTE: This action is recorded in the Run Log.
Resume a protocol that was paused.
Stop the run before the protocols ends, which may alter your
data.
Table 10. Run Status buttons and their functions (continued)
Button Function