ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 149)

Communication 4-31
Note: The port on the Communication Interface/Barrier
Box may be difficult to access because of its close
proximity to the modem. Therefore, it may be necessary to
remove the box from the EMU before connecting the
orange connector. Release the box from the back plate of
the EMU by grasping the rear edge (next to back plate) and
gently, but firmly, pulling to release the Velcro
® grips.
After seating the orange connector, verify that all
connections to the Communication Interface/Barrier Box
are secure and reseat the box onto the Velcro.
Connecting the communication cable to the Communication Interface/Barrier
Box (with the box removed from the EMU)
6. Tighten the nut on the communication cable entry fitting until
the cable is secure and cannot be moved in or out of the fitting.
7. Record the IP address of the SIM card and then insert the SIM
card into the slot in the modem.