ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 106)

Sensor Installation and Connection 3-47
Note: The new version of the Surface Combo Sensor
(p/n 8K-CS5-V2-XX-30) referenced here and throughout
this manual is undergoing final testing and evaluation.
Contact the IETG Service Centre for sensor availability.
This new version includes a different mounting plate and
involves a slightly different installation procedure, as
described in this manual, than the existing Surface Combo
Sensor (p/n 8K-CS3-V2-XX-30). To install the mounting
plate for the existing version of the sensor onto the band,
refer to the instructions below for the Ultrasonic Depth
Sensor.
 Ultrasonic Depth Sensor Slide the plate on the band
with the backstop edge of the plate facing downstream and
the two band slots facing up.
Sliding the sensor mounting plate onto the band
7. Align the sensor mounting plate with the scribe marks, and
conform the other end of the curved band with the pipe.
8. Spot drill to mark an anchor bolt location, and mount another
M6 x 55-mm anchor bolt to the pipe.
9. Hand-tighten a nut with washer to secure the other end of the
band.