ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 115)

3-56 IETG FlowHawk Manual
Connecting the Sensors to the
Monitor
After installing the ring and sensors and securing the sensor cables
to the pipe and manhole wall, connect the sensor cables to the
appropriate ports on the top of the monitor. The ports that receive
the sensors are labeled Channel 1 and Channel 2.
The FlowHawk supports the connection of two sensors in any
combination, including two of the same sensor type, to the channel
ports. However, to simplify the installation and configuration
process, IETG recommends developing a system or convention to
ensure consistency when attaching the sensors to the channel ports
and assigning the corresponding channels to the sensor devices in
Profile or Qstart.
Establish a priority or order in which particular sensors are
assigned to a specific channel and, when applicable and possible,
correspond the channel number to the monitoring point. For
example, consider always assigning the Peak Combo Sensor to
Channel 1 and the second sensor to Channel 2.
Connect the sensor cables to the monitor ports in the following
way:
1. Place the monitor in an upright position to view the monitor
connector ports.