Great Plains NTA2007HD Predelivery Manual - Manual (Page 84)

80 Great Plains Manufacturing, Inc. Contents Index NTA607HD
166-283Q Contents Index 02/09/2011
Connect WSMBs
Connect to Main Harness
320. Route the monitor harness installed at step 268
along the primary seed hose to left wing Tower A.
Refer to Figure 144
321. Select one:
467981201A INT AG HARNESS, WSMB MODULE
322. Mate the CANbus leads of WSMB harness with
the monitor cable (not shown at right).
323. Connect the 10-pin receptacle leads of harness
to the WSMB .
324. Connect the 10-pin plug leads of this harness
to the Y-cable of the row harness module .
Interconnect WSMBs
325. Select one:
467980141 10’ EXT HARNESS
326. Connect one end of this harness to the other
CANbus connectors on the WSMB harness just
installed.
327. Route this extension harness to the next
WSMB (at center section left). Follow primary seed
hoses on wings. Follow center section frame side
tubes.
328. Interconnect the two or three WSMB harnesses at
the center section.
329. Select one:
467980141 10’ EXT HARNESS
330. Interconnect the center-right WSMB with the right
wing WSMB using this extension.
Terminate CANbus
Refer to Figure 145
331. Select one:
467980126 MINI CAN TERMINATOR
Plug the terminator onto the final unconnected
CANbus data connector at the right wing WSMB
harness.
Null4:
Figure 144
WSMB Harness Connections
Q0081
167
160
168
1
152
168
168
152
168
167
168
1 160
152
152
168
Null4:
Figure 145
CANbus and Terminator
28429
162
Null4:
CANbus
Power
Null4:
CANbus
Data
152
152
162