Install lowering hose (c) – Great Plains NTA2007HD Predelivery Manual User Manual
Page 62
58
Great Plains Manufacturing, Inc.
NTA607HD
166-283Q
02/09/2011
Install Lowering Hose (C)
Refer to Figures 98-100, Figures 85, 86 on pages 52, 53 and
Figures 94 and 96 on pages 56 and 57
228. Select one:
841-453C HH1/2R2 040 3/4FJIC 3/4MORB
Check that this hose has a male QD fitting at one
end. If it does not, fit one per step 199 on page 54.
229. Select one:
811-078C TE 3/4MJIC
Attach an end port of the tee
to the FJIC end of
hose
.
230. Select one:
811-665C HH1/2R2 208 3/4FJIC
Attach either end of hose
to an end port of the
tee
.
231. Select one:
811-785C HH1/2R2 168 3/4FJIC
Attach either end of hose
to the center port of
the tee
.
232. Connect the QD end of the short hose
to cart
port C.
233. A few cm from the tee
, place hose
under
middle front station of hitch clamp
.
234. Leaving 25cm (10in) slack, route hose
, from the
top, through the front station of hitch clamp
.
235. Leaving enough slack for hose
to sag to the
wing pivot center-line, route hose
through the
lower station of left wing clamp
.
236. Leaving no slack, route hose
through the rear
lower station of outer wing clamp
.
237. Connect the free FJIC end of hose
to the
elbow
at the rod end of the left gauge wheel lift
cylinder.
238. Leaving 25cm (10in) slack, route hose
, from the
top, through the front station of hitch clamp
.
239. Leaving enough slack for hose
to sag to the
wing pivot center-line, route hose
through the
lower station of right wing clamp
.
240. Leaving no slack, route hose
through the rear
lower station of outer right wing clamp
.
241. Connect the free FJIC end of hose
to the
elbow
at the rod end of the left gauge wheel lift
cylinder.
Null4:
Null4:
Figure 98
Lowering Hydraulics at Hitch
31275
263
C
298
280
276
298
263
263
298
276
Null4:
Figure 99
LH Wing Lowering Hydraulics
31275
280
7
U
D
F
B
L
R
276
263
280
280
263
298
263
276
280
280
280
Null4:
Figure 100
RH Wing Lowering Hydraulics
31275
276
8
U
D
F
B
L
R
280
280
7
276
276
276
276
276