Great Plains NTA2007HD Predelivery Manual - Manual (Page 60)

56 Great Plains Manufacturing, Inc. Contents Index NTA607HD
166-283Q Contents Index 02/09/2011
Install Lift Hose (D)
Refer to Figure 93 and Figures 85, 86 on pages 52, 53
210. Select one:
841-453C HH1/2R2 040 3/4FJIC 3/4MORB
Check that this hose has a male QD fitting at one
end. If it does not, fit one per step 199 on page 54.
211. Select one:
811-078C TE 3/4MJIC
Attach an end port of the tee to the FJIC end of
hose .
212. Select one:
811-291C HH1/2R2 072 3/4FJIC
Attach either end of hose to an end port of the
tee .
213. Select one:
811-268C HH1/2R2 048 3/4FJIC
Attach either end of hose to the center port of
the tee .
214. Connect the QD end of the short hose to cart
port D.
215. A few cm from the tee , place hose under
middle rear station of hitch clamp .
216. Connect the free FJIC end of hose to the
elbow at the base end of the left center lift cylin-
der. Lift cylinders are the lower pair.
217. Connect the free FJIC end of hose to the
elbow at the base end of the right center lift cylin-
der.
Refer to Figure 94, 95 (page 57) and 85, 86 (pages 52, 53)
218. Select one:
811-617C HH1/2R2 140 3/4FJIC
Connect one end of hose to the elbow at the
rod end of the left center lift cylinder.
219. Leaving 25cm (10in) slack, route hose , from the
top, through the rear station of hitch clamp .
220. Leaving enough slack for hose to sag to the
wing pivot center-line, route hose through the
upper station of left wing clamp .
221. Leaving no slack, route hose through the rear
upper station of outer right wing clamp .
222. Connect the free FJIC end of hose to the
elbow at the base end of the left gauge wheel lift
cylinder.
Null4:
Figure 93
Lift Hydraulics at Hitch
31275
263
269
2
D
268
1
298
274
280
298
263
263
298
269
269
263
268
268
263
298
263 263
C01
268
1
269
2
Null4:
Figure 94
Left Wing Lift/Lower Hoses
Q0072
C05
C10
C11
274
280
4
274
274 3
274
C05
274
274
C10
274
C11
274
4