Great Plains NTA2007HD Predelivery Manual - Manual (Page 38)

34 Great Plains Manufacturing, Inc. Contents Index NTA607HD
166-283Q Contents Index 02/09/2011
Install Implement Link
Refer to Figure 51
110. Select two sets:
160-323H PIN WLDMNT 1.25 X 15.66 NR
805-255C PIN ROLL 3/8 X 2 1/2 PLT
111. Insert the pins from cart center. Fully seat the
break in the pivot pin cap in the square hole of the
cart plate.
112. Secure pins with roll pins .
Any hoist lines at the front of the link may now be
released. Any hoist lines or jack at the rear of the link will
still be needed to align the link for connection to the
implement center section.
Null4:
Connect Center Section to Link
Refer to Figure 52 (a Parts Manual illustration depicting nu-
merous parts not required for the present steps)
113. Select two sets:
160-201H WING PIVOT PIN WELDMENT
804-039C WASHER FLAT 1 1/4 SAE PLT
805-255C PIN ROLL 3/8 X 2 1/2 PLT
114. Bring the rear ends of the link tubes into alignment
with the lower holes of the center section plates.
115. From the outside, insert pivot pins . Fully seat
the break in the pivot pin cap in the square hole of
the outside implement plate.
116. Add a washer to the inside end of each pin.
Secure with roll pins .
The remainder of the cart-implement link installation con-
tinues after the rear lift-assist is assembled.
Null4:
Null4:
Figure 51
Pin Cart-Implement Link
31422
116
247
116
247
U
D
L
R
B
F
116
247
116
116 247
Null4:
Figure 52
Link Center Section
31238
247
108
108
232
U
D
F
B
L
R
108
232
247
108
232
247