Great Plains NTA2007HD Predelivery Manual - Manual (Page 83)

Great Plains Manufacturing, Inc. Contents Index Implement Assembly 79
02/09/2011 Contents Index 166-283Q
Connect Primary Hoses to Towers
316. Select two or four (double-shoot)
800-180C 2 1/2 AIR HOSE BAND CLAMP
Slide a clamp onto center section primary hoses
A&B (and F&G for double-shoot).
Slide the hoses onto their respective tower inlets for
a distance of about 5cm (2in). Position the clamps
about 2.5cm (1in) from the end of the hose and
secure. Tighten clamps only enough to prevent
hoses from working loose. be careful not to crush
hose.
317. Adjust vertical position of base towers so that top of
hose at inlets is in gentle contact with drill frame or
tower mount. Secure U-bolts to hold this position.
Do not over-tighten.
Refer to Figure 143 (which depicts the right wing at a later
stage of assembly)
318. Route wing primary hoses:
A (and E) to left wing
D (and H) to right wing
under center frame and through hoops
on rear
face of wing tubes, then out to tower mounts.
Note: Hoses G and F will cross each other to reach their
respective towers. This is normal.
319. Select two or four (double-shoot)
800-180C 2 1/2 AIR HOSE BAND CLAMP
Slide a clamp onto the free end of each primary
hose.
Slide the hoses onto to their respective tower inlets
for a distance of about 5cm (2in). Position the
clamps about 2.5cm (1in) from the end of the hose
and secure. Tighten clamps only enough to prevent
hoses from working loose. be careful not to crush
hose.
Null4:
Null4:
Figure 143
Primary Hose to Towers
Q0062
1
176
1
176