Great Plains NTA2007HD Predelivery Manual - Manual (Page 67)

Great Plains Manufacturing, Inc. Contents Index Implement Assembly 63
02/09/2011 Contents Index 166-283Q
Route Center Monitor Harness
Install Hitch Harness
Refer to Figure 112 and Figure 113
260. Select one each:
467980134 DJ 6’ HITCH EXTENSION
467980142 5’ EXT HARNESS
Interconnect these cables.
Note: If any CANbus harness is found to have a CANbus
terminator ( , not shown) installed, remove and
save the terminator for re-installation at step 331.
261. Plug the large circular connector of into the
receptacle at the cart bulkhead.
Allowing 25cm (10in) slack, route harness
through the top rear clip of hitch front clamp
.
Route harness through the top left clip of mid-
hitch clamp .
Allowing 25cm (10in) slack, route harness
through the bottom left clip of right hitch portal
clamp
.
Null4:
Null4:
Figure 112
Cart-Implement Monitor Connection
Q0074
163
4 163
153
162
163
4
164
C01
164
C02
Null4:
Figure 113
Route Monitor at Hitch
Q0068
Facing Rear
Facing Right
C02
C01
C03 C04
163
163
163
Facing Rear Facing Rear
U
D
F
B
L
R
164
C03