Great Plains NTA2007HD Predelivery Manual - Manual (Page 10)

6 Great Plains Manufacturing, Inc. Contents Index NTA607HD
166-283Q Contents Index 02/09/2011
Using This Manual
The information in this manual is current at printing.
Some parts may change to assure top performance.
Definitions
The following terms are used throughout this manual.
A crucial point of information related to the preceding topic.
Read and follow the directions to remain safe, avoid serious
damage to equipment and ensure successful assembly.
Note: Useful information related to the preceding topic.
Right-hand and left-hand as used in
this manual are determined by facing
the direction the machine will travel
while in use unless otherwise stated.
An orientation rose in some line art
illustrations shows the directions of:
Up, Back, Left, Down, Front, Right.
Call-Outs
Figures
Photo Advisory:
None of the photographs in this manual were taken during an
actual export assembly. They may include parts, assemblies,
and other artifacts that will not be present at the same point in
an actual export assembly. Rely on the text narrative. Rely on
the Figures only insofar as they support the text narrative.
Null4:
About Parts
Fasteners
Fasteners called out are often loosely installed in one of
the two parts to be joined, and must be removed before
the parts are mated. To avoid mix-ups and misplaced
parts, do not remove fasteners from shipping locations
until the “Select” instruction that calls for those parts.
Tags
Some parts have engraved metal tags attached. These
tags are for parts ID and may be removed and discarded
as the part is installed. In some cases, the tag must be
removed or it will interfere with part installation. Parts
may alternatively be marked with grease pencil. These
marks may be left on and removed at close-out.
Assembly and Setup Assistance
To order additional copies of pre-delivery instructions,
operator or parts manuals, write to the following address.
Include model numbers in all correspondence. If you do
not understand any part of this manual or have other
assembly or setup questions, assistance is available.For
further assistance, contact:
Product Support
Great Plains Mfg. Inc., Service Department
PO Box 5060
Salina, KS 67402-5060
785-823-3276
MetaData: End of “Introduction”
to Single-character callouts in the ranges
1-9, a-z or A-Z identify elements from
only the most recently referenced Figure
or Figures. These numbers and letters
may be re-used for other elements on
other pages.
to Three-character callouts in the range
101 to 308 reference Great Plains part
numbers from a common Part List in the
Appendix. These numbers always refer
to the same part in all cases.
U
D
F
B
L
R
1 9
101 308