Dismount final wing, Install wings, Install wing extensions – Great Plains NTA2007HD Predelivery Manual User Manual
Page 47

Great Plains Manufacturing, Inc.
Implement Assembly
43
02/09/2011
166-283Q
Dismount Final Wing
Refer to Figure 69
161. Loosen the nuts on the four sets of U-Bolts
and
two straight bolts
that secure wing section to rack
mounts. adjust lifter until fasteners are not in tensi-
uon.
162. Remove nuts completely. Remove fasteners. Lift
rack free of wing. The rack and fasteners are not
reused.
Null4:
Install Wings
Install Wing Extensions
Wing extensions are different for standard (STD) down-
flex, and for each row spacing of limited (LTD) down flex.
Before installing extensions:
• Check extension part numbers against the configura-
tion ordered, per sequence number/feature code:
• Make sure all four extensions are the same part num-
ber. Different extensions cannot be mixed.
Refer to Figure 70
163. Select four each of one of the following:
160-319H 10 DEGREE WING PIVOT EXT WLDMT
160-334H 6 LIMITED FLEX WING FR EXT
160-335H 7.5 LIMITED FLEX WING FR EXT
and four sets:
802-075C HHCS 1-8X7 GR5
803-168C NUT HEX TOP LOCK 1-8 PLT
Orient each extension
as shown, align the
holes in the wing ends of the side plates with the
round tubes in the wing tool bars. Insert bolts
to
hold alignment. Add lock nuts
but do not fully
tighten at this step.
Null4:
Figure 69
Release Final Racked Wing
Q0050
Code - Flex Spacing
Part No.
40
- STD
NTA607HD-3275 (7.5in)
160-319H
41
- LTD
NTA607HD-3275 (7.5in)
160-335H
40
- STD
NTA607HD-4006 (6in)
160-319H
41
- LTD
NTA607HD-4006 (6in)
160-334H
Null4:
Figure 70
Position Wing Extension Weldments
31244
U
D
F
B
L
R
185
215
112
112
112
112
185
215
112
185
215