Great Plains NTA2007HD Predelivery Manual - Manual (Page 80)

76 Great Plains Manufacturing, Inc. Contents Index NTA607HD
166-283Q Contents Index 02/09/2011
Install Wing D.S.Towers
Refer to Figure 136
Note: The double-shoot (d.s.) tower turret is below
the base tower turret at close-out. It may be
necessary to loosen U-bolts and raise the posi-
tion of the d.s. tower to avoid interference. Leave
the U-bolts only snug for adjustment at step 294.
302. Select two of either:
168-434K 10 OUTLET DOUBLE SHOOT TOWER
168-436K 8 OUTLET DOUBLE SHOOT TOWER
If the towers already have letter labels, choose
towers E and H. Tower E mounts on base wing
tower A. Tower H mounts on base wing tower D.
303. Select sixteen sets (not all shown):
802-091C HHCS 1/2-13X1 1/2 GR5
804-015C WASHER LOCK SPRING 1/2 PLT
803-020C NUT HEX 1/2-13 PLT
With the d.s. tower to the inside, and its turret
below the base turret, secure the d.s. tower mount
angle
to the rear of the base tower’s
mount .
Refer to Figure 137 (depicting a view from beneath the drill)
304. If not already loosened, loosen U-bolts . Adjust
the d.s. tower inlets to point toward approxi-
mately toward wing gauge wheels. Adjust the verti-
cal position of the d.s. tower to leave a gap of 2.5cm
(1in) between turrets (to ease access to cap bolts at
later steps). Leave U-bolts only snug for further
adjustment at a later step.
Refer to Figure 131 on page 73
If the towers already have letter labels, skip step 305 and
step 306.
305. Clean dry the d.s tower tubes just above the inlet
bend.
306. Select the:
848-553C DECAL BIN-PRIMARY LINE SHEET
From the decal sheet , select letters E and H.
Apply letter decal E to the left-wing d.s. tower tube.
Apply letter decal H to the right-wing d.s. tower tube.
Null4:
Figure 136
Install Wing D.S. Tower
31271
4
188
140
136
139
129
3
140
139
4
140
188
225
206
140
129
136
Null4:
Figure 137
Wing D.S. Tower Inlet
Q0060
F
B
R L
3
4
3
302
302