Great Plains NTA2007HD Predelivery Manual - Manual (Page 26)

22 Great Plains Manufacturing, Inc. Contents Index NTA607HD
166-283Q Contents Index 02/09/2011
Install Manual-Pak™
Refer to Figure 29
62. Select one:
118-652D MANUAL PAK MOUNT
and two:
806-156C U-BOLT 5/16-18 X 4 1/32 X 5
and four sets:
804-010C WASHER FLAT 5/16 USS PLT
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
Attach the mount to the rear tongue cross-tube.
Install with short break of mount under tube, and
front face as far forward as possible. Loosely secure
the U-bolts
with flat washers , lock
washers and nuts .
63. If the Manual-Pak™ is already attached to the
mount , skip to step 64, otherwise select one:
817-516C MANUAL PAK 1" W/ GASKET
and four sets:
802-005C HHCS 1/4-20X1 GR5
817-042C MINI END WHEEL PRESS WHEEL
803-088C NUT HEX LOCK 1/4-20 FLG
Insert two bolts , from the rear, at the top holes
of the mount . Insert two more at lower center
holes. Hold all bolts in place with elastomer
standoffs
.
Release top latches of Pak . Open pak, and fit
onto bolts (latches on top, hinge on bottom).
Secure with lock nuts . Tighten nuts only until
elastomer standoffs begin to compress. Do not
tighten to full
1 ⁄
4
-20 torque spec.
64. Slide pak assembly as far left as possible that still
allows the pak cover to be opened far enough to
access contents. Tighten the U-bolt nuts to
5 ⁄
16
-18
torque spec.
65. Select one:
167-085B MANUAL SEED RATE ADC2350/2350B
Place the Rate manual in the pak.
Close and latch cover.
Null4:
Figure 29
Manual Pak
Q0040
U
D
F
B
L
R
177
251
103
282
213
283
221
204
222
103
251
222
221
204
103
251 222
221 204
283
103
283
177
282
213
177
103
282
283
177
213
134