Great Plains NTA2007HD Predelivery Manual - Manual (Page 37)

Great Plains Manufacturing, Inc. Contents Index Implement Assembly 33
02/09/2011 Contents Index 166-283Q
Install Cart-Implement Link
Release Cart-Implement Link
Refer to Figure 49 (which depicts a U-bolt already removed)
106. Support the cart-implement link:
160-315H NTA607HD FRONT PULL LINK WLDMT
with at least two hoist straps.
160-315H is the larger of the two link weldments.
The other (
160-316H) is the rear lift-assist link.
As racked, the upper (wider) end of the cart-imple-
ment link is the cart end. The large lug
will be up
upon installation.
107. Remove the U-bolts securing the link to the rack.
These U-bolts are not re-used.
108. Position the link near the cart rear, cart end toward
cart and lug side up.
Align Link with Cart
Refer to Figure 50 and Figure 51 on page 34
109. Align the front tubes of the link weldment
with
the holes in the plates at the lower rear cart tube.
Null4:
Figure 49
Release Cart-Implement Link
Q0028
110
111
2
1
110
111
1
2
Null4:
Figure 50
Align Cart-Implement Link
Q0039
110
110