Rockwell Automation 20B PowerFlex 700 AC Drives Vector Control (v4.001 and up) User Manual
Page 22
22
Rockwell Automation Publication 20B-UM002G-EN-P - July 2014
Chapter 1
Programming and Parameters
MON
IT
O
R
Me
teri
ng
018 [PTC HW Value]
Value present at the drive's PTC input terminals.
Default:
Min/Max:
Units:
Read Only
–/+5.00 Volts
0.01 Volts
021 [Spd Fdbk No Filt]
Displays the unfiltered value of the actual motor
speed, whether measured by encoder feedback
or estimated.
Default:
Min/Max:
Units:
Read Only
–/+400.0 Hz
–/+24000.0 RPM
0.1 Hz
0.1 RPM
022 [Ramped Speed]
Value of commanded speed after Accel/Decel,
and S-Curve are applied.
Default:
Min/Max:
Units:
Read Only
–/+400.0 Hz
–/+24000.0 RPM
0.1 Hz
0.1 RPM
023 [Speed Reference]
Summed value of ramped speed, process PI and
droop. When FVC Vector mode is selected, droop
will not be added.
Default:
Min/Max:
Units:
Read Only
–/+400.0 Hz
–/+24000.0 RPM
0.1 Hz
0.1 RPM
024 [Commanded Torque]
Final torque reference value after limits and
filtering are applied. Percent of motor rated
torque.
Default:
Min/Max:
Units:
Read Only
–/+800.0%
0.1%
025 [Speed Feedback]
Displays the lightly filtered value of the actual
motor speed, whether measured by encoder
feedback, or estimated.
Default:
Min/Max:
Units:
Read Only
–/+400.0 Hz
–/+24000.0 RPM
0.1 Hz
0.1 RPM
Dr
iv
e Da
ta
026 [Rated kW]
Drive power rating.
Default:
Min/Max:
Units:
Read Only
0.00/3000.00 kW
0.01 kW
027 [Rated Volts]
The drive input voltage class (208, 240, 400 etc.).
Default:
Min/Max:
Units:
Read Only
0.0/65535.0 VAC
0.1 VAC
028 [Rated Amps]
The drive rated output current.
Default:
Min/Max:
Units:
Read Only
0.0/65535.0 Amps
0.1 Amps
029 [Control SW Ver]
Main Control Board software version.
Default:
Min/Max:
Units:
Read Only
0.000/65535.000
0.001
Fil
e
Gr
oup
No
.
Parameter Name & Description
See
page 16
for symbol descriptions
Values
Rela
ted
FV