INFICON MDC-260 Thin Film Deposition Controller - Manual (Page 51)

MDC-260 DEPOSITION CONTROLLER
PROGRAMMING AND CONTROLLER SETUP 4-15
Each process is referenced by a twelve-character alphanumeric process name.
You enter a process name using the alphanumeric keypad as described in Section
4.1.2. Please note that the active process name is displayed in the upper left-hand
corner of all the status screens.
Edit Password (four character alphanumeric field)
The Edit process password allows you to lock out other users from editing a
process unless the correct password is known. To set this password, highlight the
Edit password field, type in your password then press the Enter key. A message
will pop up asking for verification to change the password. Press “1” to confirm
and “0” to cancel the change. Each time you want to edit this process, you will be
asked to enter the correct password. Once a password has been entered, this
parameter will not be displayed until the password has been entered again.
The default for this parameter is '0000'.
NOTE: Please note that once the password has been changed, the process
cannot be modified unless the correct password is entered so you must
remember your passwords!
View/Run Password (four character alphanumeric field)
The View/Run process password allows you to lock out other users from viewing
and/or running a process unless the correct password is known. To set this
password, highlight the Edit password field, type in your password then press the
Enter key. A message will pop up asking for verification to change the password.
Press “1” to confirm and “0” to cancel the change. Each time you want to view or
run this process, you will be asked to enter this password. Please note that the
view function of this password is ignored if the Edit Password is not set. Once a
password has been entered, this parameter will not be displayed until the
password has been entered again.
The default for this parameter is '0000'.
NOTE: Please note that once the password has been changed, the process
cannot be modified unless the correct password is entered so you must
remember your passwords!
Layer (001 to 250)
This column shows the layer number in the process. Please note that with the
cursors on a layer number you can copy or delete this layer.
Thickness (000.0 to 999.9)
This parameter defines the desired thickness for the layer. The default for this
parameter is 0.000 KÅ.
Material
This parameter defines the material for this layer. The layer material is selected
from the list of materials defined in View/Edit Material. Therefore, you should
define all of the necessary materials for the process before defining the process.
See EDIT MATERIAL PASSWORD section 4.3.2.