Apple Motion 2 Tutorials - Manual (Page 26)

26 Tutorial 1 The Motion Interface
To show an object in the Inspector:
1 Make sure the upper green box object is selected.
2 Click the Inspector icon in the upper-right corner of the Dashboard.
Note: You can also do one of the following to display the Inspector:
• Click the Inspector tab in the Utility window.
• Press Command+3.
• Click the Inspector icon on the right side of the Toolbar.
The Inspector appears (is brought to the front). In the Inspector, four tabs divide the
various parameters into categories: Properties, Behaviors, Filters, and Shape (Object).
Note: The fourth tab is called the Object tab (in this example, the Shape tab), and
changes depending on the type of object selected. For example, if a mask is selected,
the last tab is the “Mask” tab.
3 Optionally, click the various tabs to see the controls available for the object.
4 Click the Properties tab.
5 In the Shear parameter row, drag the first value slider (drag in the value field) to set an
X shear value of approximately 40 degrees.