Apple Motion 2 Tutorials - Manual (Page 231)

Tutorial 5 The Replicator 231
To add an opacity change to the Sequence Replicator behavior:
1 In the Inspector, select the Behaviors tab.
2 Choose Opacity from the Add Parameter pop-up menu.
3 Set Opacity to 0 percent.
With Opacity set to 0, the objects in the replicator move from 100 percent opacity at
the beginning of the Sequence Replicator behavior to 0 percent at the end.
To add a scale change to the Sequence Replicator behavior:
1 Choose Scale from the Add Parameter pop-up menu.
2 Set Scale to 85 percent.
The objects in the pattern begin their life at a scale of 100 percent, and end at a scale of
85 percent.
3 Save your project (press Command+S).
Finally, add an animateable parameter to the Sequence Replicator behavior: Position.
To add a position change to the Sequence Replicator behavior:
1 Choose Position from the Add Parameter pop-up menu.
2 In the Layers list, select the pattern.
Parameter Behaviors
Don’t forget, you can add a Parameter behavior, such as Oscillate, Random, or Ramp,
to any of the Sequence Replicator parameters.
Experiment by adding Parameter behaviors to your Sequence Replicator parameters.