Konica Minolta bizhub 222 - Manual (Page 78)

Transmission 2
362/350/282/250/222/200 2-35
T
ran
sm
iss
ion
Chapter 2
2.10 When unable to send
If the fax could not be sent because the recipient’s line was busy, it will be
called again (auto redial).
If a different fax is queued, the fax number is automatically redialed after the
queued fax is sent.
If the fax could not be sent even after automatically redialing, a transmission
report is printed. This report contains part of the first page of fax that could
not be sent (except if the “Quick Scan TX” function was used).
!
Detail
As a factory default, this machine is set to automatically redial up to 5
times at 1 minute intervals. The settings for the number of redials and the
interval can be changed. For details, refer to “Specifying the reception
mode and the number of rings (RX Functions)” on page 10-44.
Software switch settings can be specified to select whether or not the
first page of the image is added to the results report. For details on the
software switch settings, refer to “Specifying software switch settings
(machine functions)” on page 10-67.
If it is not necessary that the transmission report be printed, the setting
can be changed. For details, refer to “Specifying report output settings
(Report Settings)” on page 10-48.
To send the fax again
If a fax could not be sent, follow the procedure described below to try send-
ing it again.
1
Touch [Job List], then [Type], and then search for documents that could
not be sent.
If [Retry] or [Change Destination] appears, the fax can be resent without
having to scan the document again.
2
Touch [Retry] to send the fax to the same recipient.
– To send the fax to a different recipient, touch [Change Destination].
– If neither button appears, scan the document and try faxing it again.