Konica Minolta bizhub 222 - Manual (Page 160)

Registering/specifying settings 9
362/350/282/250/222/200 9-13
Regist
er
ing/
spe
c
if
ying set
ti
ngs
Chapter 9
5
Touch the button where
the one-touch dial but-
ton is to be copied.
The settings specified
for the one-touch dial
button is copied.
6
Touch [Enter] in each screen until the standby screen (initial screen) ap-
pears.
Registering/deleting a secondary destination
In addition to the main destination, a secondary destination can be regis-
tered with the one-touch dial button in case the transmission to the main
destination failed.
1
Perform steps 1 through 4 of the procedure for registering a one-touch
dial button, until the screen for selecting a one-touch dial button ap-
pears.
– For details, refer to “Programming a one-touch dial button with a
fax number” on page 9-4.
2
Touch the one-touch dial button where the secondary destination is to
be registered.
3
Touch [One-Touch], then [Sub Address Registration].
– If a secondary desti-
nation is already reg-
istered, touch
[Switch Sub/Main
Addresses] to switch
the secondary and
main destinations.