Konica Minolta bizhub 222 - Manual (Page 182)

Registering/specifying settings 9
362/350/282/250/222/200 9-35
Regist
er
ing/
spe
c
if
ying set
ti
ngs
Chapter 9
11
Touch [Remote Input Check].
12
Touch either [ON] or
[OFF] to specify a setting
for “Remote Input
Check”, and then touch
[Enter].
– If “ON” was selected,
type in an F-code
password.
? What does the “Re-
mote Input Check”
function do?
% This function specifies whether or not registering a document in this
machine’s confidential box from another fax machine is regulated
with a password.
13
Check the information to
be registered, and then
touch [Enter].
– To change a setting,
touch the button for
the setting to be
changed, and then
specify the new set-
ting.
14
Touch [Enter] in each screen until the standby screen (initial screen) ap-
pears.
2
Note
If software switch settings were specified to limit use of the FAX Regis-
tration screen to the administrator, [FAX] does not appear in the User Set-
ting screen. In this case, destination can only be registered, edited and
deleted in Administrator mode. For details on the software switch set-
tings, refer to “Specifying software switch settings (machine functions)”
on page 10-67.