Konica Minolta bizhub 222 - Manual (Page 154)

Registering/specifying settings 9
362/350/282/250/222/200 9-7
Regist
er
ing/
spe
c
if
ying set
ti
ngs
Chapter 9
9
Check the information to
be registered, and then
touch [Enter].
– To change a setting,
touch the button for
the setting to be
changed, and then
specify the new set-
ting.
? What does the three-
digit number begin-
ning with “#” refer to?
% The one-touch dial button number appears as a three-digit number
beginning with “#”. A one-touch dial button number is specified for
each one-touch dial button. Instead of touching the one-touch dial
button, the recipient can be specified by pressing [#] key, then en-
tering the one-touch dial button number (between 000 and 539).
10
Touch [Enter] in each screen until the standby screen (initial screen) ap-
pears.
2
Note
If [One-Touch], then [Sub Address Registration] is touched, a recipient
can be registered for automatic selection. For details, refer to “Register-
ing/deleting a secondary destination” on page 9-13.
If software switch settings were specified to limit use of the FAX Regis-
tration screen to the administrator, [FAX] does not appear in the User Set-
ting screen. In this case, destination can only be registered, edited and
deleted in Administrator mode. For details on the software switch set-
tings, refer to “Specifying software switch settings (machine functions)”
on page 10-67.