Konica Minolta bizhub 222 - Manual (Page 276)

Utility mode 10
362/350/282/250/222/200 10-93
Utility mode
Chapter 10
Specifying settings for when copying is finished using the ADF (mode
429)
Specify whether or not all settings are reset when copying is finished using
the ADF.
Settings at time of purchase
Specifying the setting
During the production of this unit, the settings in the shaded cells were se-
lected. The numbers on the right side indicate the page numbers with de-
scriptions for the corresponding function.
Bit 7 6 5 4 3 2 1 0
Setting 0 0 0 0 0 0 0 0 (HEX: 00)
Bit Description Setting Description Page Refer-
ence
7, 6 ----------------------- 00 *Do not change these bits
when specifying settings
for this function. ----------
5 Specifies whether or
not all settings in the
Basics screen are
reset when copying
is finished using the
ADF. 0 Does not perform the au-
tomatic panel reset oper-
ation ----------
1 Performs the automatic
panel reset operation
4, 3, 2, 1, 0 ----------------------- 00000 *Do not change these bits
when specifying settings
for this function. ----------