Konica Minolta bizhub 222 - Manual (Page 252)

Utility mode 10
362/350/282/250/222/200 10-69
Utility mode
Chapter 10
3
Touch [Mode Selection],
and then use the keypad
to type in the mode
number.
4
Specify a mode setting
by using either bits or
hexadecimal values.
– To specify the bits,
touch [Bit Selection],
touch [
←] or [→] to
move the cursor to
the bit to be
changed, use the
keypad to specify the
bit, and then touch
[Enter].
– To specify the hex
value, touch [HEX
Selection], use the
keypad or touch [A]
through [F] to specify
the value, and then
touch [Enter].
5
To change the setting for a different mode, repeat steps 3 and 4.
6
Touch [Enter] in each screen until the standby screen (initial screen) ap-
pears.
7
Turn the machine off, then on again.