Konica Minolta bizhub 222 - Manual (Page 269)

10 Utility mode
10-86 362/350/282/250/222/200
Utility mode
Chapter 10
Specifying administrator forwarding settings (mode 198)
You can specify whether a received document is forwarded to a destination
specified by the administrator.
Settings at time of purchase
Specifying the setting
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
(*) Bit 7 of mode 198 is enabled only when “1 (transmit)” is specified.
Bit 7 6 5 4 3 2 1 0
Setting 1 1 0 1 0 0 0 0 (HEX: D0)
Bit Description Setting Description Page Refer-
ence
7 Specifies whether a
received document
is forwarded to a
destination speci-
fied by the adminis-
trator. 0 Not forwarded p. 10-51
1 Forwarded
6 Specifies whether to
enable TX Forward-
ing when scan-
ning.(*) 0 Not forwarded ----------
1 Forwarded
5, 4 Specifies the print
conditions of trans-
mission reports for
TX Forwarding.(*) 00 Not output p. 10-51
01 Undeliverable
10 Always prints
11 *Do not specify this set-
ting for this function.
3, 2, 1, 0 ----------------------- 0000 *Do not change these bits
when specifying settings
for this function. ----------