Konica Minolta bizhub 222 - Manual (Page 74)

Transmission 2
362/350/282/250/222/200 2-31
T
ran
sm
iss
ion
Chapter 2
2.7 Faxing after using the telephone (manual faxing)
If a telephone is connected, a document can be sent after talking to the re-
cipient on the telephone. This feature is useful, for example, if you want to
notify the recipient that you are sending a fax.
To send a fax manually
0 In order to send a fax manually, a telephone must be connected.
0 When faxing after using the telephone, feed the document using the ADF.
1
Press the [Fax/Scan] key to display the Fax mode screen.
2
Load the document into the ADF.
3
Lift up the receiver of the external telephone.
– Instead, touch [On-hook Dial], and then, after the recipient answers,
pick up the telephone receiver.
A dial tone can be heard.
4
Touch [One-Touch] or [Direct Input], and then specify the recipient.
The recipient is dialed so you can talk to them.
? I heard a beep, but why can’t I talk to the recipient?
% If the recipient’s fax machine is set to receive faxes automatically
(automatic reception), a beep is sounded without the recipient an-
swering the phone. In this case, you cannot talk to the recipient.
5
After talking to the recipient, have them press the [Start] key (transmis-
sion button) on their machine.
Once the recipient’s fax machine is ready, a beep is heard.
6
Press the [Start] key.
The transmission begins.
7
Place the telephone receiver on its hook.
2
Note
If software switch settings were specified to limit dialing, a fax cannot be
sent by directly typing in the fax number. For details on the software
switch settings, refer to “Specifying software switch settings (machine
functions)” on page 10-67.