HID HDPii Plus User Guide 2.0 - Manual (Page 82)

HDP5000 & HDPii Card Printer Encoder User Guide_L000950, 2.0
Page 82 of 103 December 2012
© 2012 HID Global Corporation. All rights reserved
7.2 Accessing the Clean Printer tab
Figure 15 - Cleaning Card setup for Magnetic Encoder
7.2.1 Cleaning the Printer Platen Roller and Card Feed Rollers
Perform this procedure approximately every 1,000 prints to maintain a consistent print quality.
( Note: The Card Feed Rollers move the card throughout the print process. Keep rollers clean to
prevent card jams and card contamination. This cleaning process ultimately leads to better print
quality and extended Printhead life.)
Step Procedure
1 From the Printer Driver, click Toolbox to bring up the Clean Printer tab.
2 Follow the instructions from the Clean Printer tab on the Driver.
Note: If your Printer is equipped with a Magnetic Encoder, you must insert the Cleaning Card with the
printed side up and with a small Liner Strip towards the front of the Printer.
3 Replace the printing supplies and close the Print Stations after the Rollers are clean and completely
dry.