HID EDGE EVO Hi-O Interface Door Module Installation Guide - Manual

The EDGE EVO Door module is wired to interface with the EDGE EVO device (Hi-O Networked Controler & Reader or Networked
Controller) with electronic door components. Designed for providing interface to traditional discrete access inputs and outputs, the Door
Module provides four input analog/digital inputs and two outputs. Configure the Door Module in two ways; as a primary door interface to
REX, Door Position Switch, Battery Fail, Power Fail, Lock, and Aux (Group 1) or as a general purpose input/output module (Group 2).
Specifications
CONDITIONS VOLTAGE DC (VDC) CURRENT (Amp)
OPERATING
TEMPERTURE CABLE LENGTH
UL REF
NUMBER
Input
DC Input (NSC) 10.8 to 24VDC 0.04Amp
32° - 122°F
(0° - 50° C)
Inputs = 500 ft (150 m)
Outputs = 500 ft (150 m)
Hi-O CAN Bus Total Length 100 ft (30 m) -
22 AWG ● 0.65mm ● 0.33mm 2
Maximum between drops 30 ft (10 m)
22 AWG ● 0.65mm ● 0.33mm 2
MEDMAxNN
x = K for Black
G for Grey
DC Input (MAX) 10.8 to 24VDC 0.80Amp
Supervised inputs
(AC, Batt, REX, Door Mon) (MAX)
0-5V Reference 0.005 (Sink)
Output
Strike / AUX
NC or NO
DC Output
Regulated or
Unregulated (Wet)
Jumpers
10-24VDC 0.31 to 0.70Amp *
Dry Jumpers +12 to +24VDC External 2.00 ** Amp
* Shared between relays
** Each relay
EDGE EVO ®
Door Module
EDM-M
I
nstallatIon
G
uIde
82342-901, Rev B.1
October 2011
© 2009 - 2011 HID Global Corporation. All rights reserved.
15370 Barranca Parkway
Irvine, CA 92618-2215
USA