HID HDPii Plus User Guide 2.0 - Manual (Page 67)

HDP5000 & HDPii Card Printer Encoder User Guide_L000950, 2.0
December 2012 Page 67 of 103
© 2012 HID Global Corporation. All rights reserved.
LCD Error Message Cause Solution
Job Data Error
(PC Error Message No.
106)
The print data sent to the Printer is
corrupt or has been interrupted.
Reset the Printer and try again.
If this problem persists, call for technical
assistance.
Lam 1 Tag Err
(PC Error Message No.
259)
A RFID read or write error occurred
on Cartridge 1.
Retry, and if it fails again the material cannot
be used.
Lam 2 Tag Err
(PC Error Message No.
260)
A RFID read or write error occurred
on Cartridge 2.
Retry, and if it fails again the material cannot
be used.
Lam Async Error
(PC Error Message No.
245)
The Printer timed out waiting for
communication from the Laminator.
Check Lam power/connections and restart
the Printer.
Lam Card Jam
(PC Error Message No.
53, 212, 214, and 215)
A jam occurred somewhere
between the Printer and the
Laminator.
Open covers and clear the obstruction/jam.
Lam Check Card
(PC Error Message No.
213)
A jam occurred inside the
Laminator.
Open Lam cover and clear the obstruction.
Lam Com Error
(PC Error Message No.
246)
There was a communication failure
between the Printer and Laminator.
Check Lam power/connections and restart
the Printer.
Lam Error
(PC Error Message Nos.
237 and 238)52
A generic unknown error as
occurred.
Reset the Printer and try again. If this
problem persists, call for technical
assistance.
Lam Card Not Ejected
(PC Error Message No.
216)
The card is not ejected from the
Laminator.
The Lamination material is stuck to the card.
Lam Handler Startup Error
(PC Error Message No.
66)
A problem was detected during
Printer start-up.
Reset the Printer and try again.
If this problem persists, call for technical
assistance.
Lam Handler Startup Error
(PC Error Message No.
141)
After powering up the Printer, the
Laminator was detected, but an
error occurred which would prevent
its use.
Check Laminator power and connections and
restart the Printer.
Lam Internal Error
(PC Error Message No.
48)
A generic unknown error as
occurred in the Laminator.
Check Laminator power and connections and
restart the Printer.
Lam No Film
(PC Error Message No.
157)
There is no material loaded in the
Laminator.
Load Laminator material.
Lam Timeout
(PC Error Message No.
247)
The Printer timed out while
processing information related to
the Laminator.
Check Lam power/connections and restart
the Printer.