HID HDPii Plus User Guide 2.0 - Manual (Page 21)

HDP5000 & HDPii Card Printer Encoder User Guide_L000950, 2.0
December 2012 Page 21 of 103
© 2012 HID Global Corporation. All rights reserved.
3.2.4 Using the InTM Film Low message
The default setting is checked.
• If checked, InTM Film Low message box is displayed with every print job when Printer
reports low InTM film to the Driver.
• Do not show this message again. The check box allows the user to suppress the
message per Driver instance. Default = unchecked.
3.2.5 Using the Clean Printer message
The default setting is checked. If checked, a clean printer message displays after 3000 prints.
3.2.6 Using the Error Status message
The default setting is checked. If checked, error messages (with solutions) display when an error
occurs.
3.2.7 Using the Password Prompt message
The default setting is checked.
• If checked, a dialog message requests a password to continue printing.
• Password protection is set and activated in the Workbench.
3.2.8 Selecting the Display Language
There are two areas where you change interface languages, the workstations Driver software and
the printer display.
Select the Driver software language when installing the driver. For changing the Driver software
language after the initial installation, use the Toolbox.
The default printer language is English. By sending a language pack file to the printer, the printer
is capable of other languages. Change the printer language by using the Toolbox (once sending
the proper language pack to the printer). Only the languages available within the printer firmware
(as downloaded through the language packs) are choices in the dropdown menu. Contact
Technical Support ( support.hidglobal.com ) to obtain printer language packs. See Figure 2 -
Configuration, page 19.