HID HDPii Plus User Guide 2.0 - Manual (Page 59)

HDP5000 & HDPii Card Printer Encoder User Guide_L000950, 2.0
December 2012 Page 59 of 103
© 2012 HID Global Corporation. All rights reserved.
3.13.6 Selecting the Auto Detect Laminate button
Step Procedure
1 Check Auto Detection for allowing the printer driver to correct the lamination values.
2 If Auto Detection is unchecked and the lamination values do not match, the LCD displays a Wrong
Laminate error.
3.14 Using the K Panel Resin tab
Use this tab to adjust the Print All Black with K Panel (options) and the Defined Areas. Use this
tab to control where the resin black (K) Panel of a full-color Ribbon is printed. ( Note: When
Disable Printing under the Device Options tab is selected, this tab will be active while all functions
will be grayed out.)
• If printing with a Ribbon type that does not have a K Panel, such as the YMC Ribbon type,
all K Panel Resin options will be grayed out. Resin black text is desirable due to its sharp,
saturated color and resin black barcodes are required to ensure readability when scanned
by an infrared barcode reader. ( Note: The Printer Driver will automatically print all
TrueType black text and TrueType barcodes only with the resin black (K) Panel of the Print
Ribbon by default.)
• If printing black text or barcodes that are not TrueType fonts or black graphics, select one
of the three options listed under Print All Black with K Panel (see the next page). (Note:
The Printer Driver will print areas of the image where it finds black coloring with the Print
Ribbon's resin black (K) Panel as specified by each of the following options.)
Figure 11 - K Panel Resin