HID EDGE EVO EIM-M Input Module Installation Guide - Manual

Specifications
CONDITIONS VOLTAGE DC (VDC) CURRENT (Amp) POWER (W)
OPERATING
TEmPERTURE
CAbLE LENGTh
UL REFERENCE
NUmbER
Inputs
DC Input (NSC)
+12VDC 0.03 Amp 0.36
32° - 122°F
(0° - 50° C)
Input Circuits
500 ft (150 m)
= 22 AWG ● 0.65mm ● 0.33mm 2
18 AWG ● 1.02mm ● 0.82mm 2
hi-O CAN bus Total Length 100 ft (30 m) -
22 AWG ● 0.65mm ● 0.33mm 2
Maximum between drops 30 ft (10 m)
22 AWG ● 0.65mm ● 0.33mm 2
MEIMAxNN
X = K for Black
G for Gray
+24VDC 0.03 Amp 0.72
DC Input (MAX)
+12VDC 0.04 Amp 0.48
+24VDC 0.04 Amp 0.96
Supervised Inputs (MAX) 0 to 5 VDC Reference 0.005 Amp (Sink) 0.025
NSC = Normal Standby Condition
Wiring
Input 1 Input 2
10 P3 1
Hi-O Group Select Jumper
Short = Group 1, Open = Group 2
Outside Door Inside Door
( )
4 P1 1
* *
- +
Input 3 Input 4
- + - + - +
* Internal Optical Tamper Disable Jumper
CAN V+
GND
CAN H
CAN L CANbus
Internal Optical Tamper
To disable the internal optical tamper sensor, attach a jumper wire from P3 pin 1 to P3 pin 2.
Note: If desiring an external tamper, wire an unsupervised Normally Closed contact, and replace the jumper.
EDGE EVO
®
Input Module
EIM-M
I
nstallatIon
G
uIde
82340-901, Rev C.2
March 2013
© 2009-2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
15370 Barranca Parkway
Irvine, CA 92618-2215
USA
Optional
Supervised Inputs
1-6K
N/O
1-6K
N/C
1-6K
1-6K
N/O
Designed for interfacing to general purpose inputs typically not associated
with standard access point control, the Input Module provides an interface
to four input analog/digital inputs. The module is always configured as
general purpose input.