beautypg.com

5 card lamination module, 1 adjusting the lamination placement on the card, Card lamination module – HID HDPii Plus User Guide 2.0 User Manual

Page 79: Printer unit: reviewing the card lamination module, Figure 14 - adjusting lamination module, 5card lamination module

background image

HDP5000 & HDPii Card Printer Encoder User Guide_L000950, 2.0

December 2012

Page 79 of 103

© 2012 HID Global Corporation. All rights reserved.

5

Card Lamination Module

The Printer supports the attachment of an optional Card Lamination Module. Select

Printer

Models Support for the attachment of an optional Card Lamination Module. This Module can be

ordered pre-installed or separate as a field upgradeable Module.
Once attached, the Card Lamination Module allows you to apply certified overlaminates for more

secure, tamper-resistant cards. This section explains all aspects of the Card Lamination Module's

operation and the overlaminate materials available.

5.1

Printer Unit: Reviewing the Card Lamination Module

WARNING: The Printer’s Transfer Roller reaches temperatures exceeding

350° F (175° C). Use extreme caution when operating the Laminator. Never

touch the Transfer Roller unless the Printer has been turned off for at least

20 minutes.

5.1.1 Adjusting the Lamination Placement on the Card

The Card Lamination Module provides an adjustable Lamination Placement knob that allows you

to fine-tune where the lamination is being placed on the card.

Figure 14 - Adjusting Lamination Module

Step

Procedure

1

The Lamination Placement Adjustment Knob is the light gray knob to the right of the Lamination

Cartridges.

The printer will have one or two film cartridges loaded (depending on whether this is a Single or

Dual-Side Lamination Module).

2

Print a test card to see if the Lamination needs to be adjusted.

Turn the knob to the right (the negative sign) to move the patch toward the front edge of the

Lamination Module. Turn the knob to the left (the positive sign) to move the patch toward the back

edge of the lamination module.

Refer to the instruction diagram label located on the open front cover to make this adjustment.