HID HDPii Plus User Guide 2.0 - Manual (Page 32)

HDP5000 & HDPii Card Printer Encoder User Guide_L000950, 2.0
Page 32 of 103 December 2012
© 2012 HID Global Corporation. All rights reserved
3.7.15 Using the Film Takeup Transfer Tension Setting
Negative (-) adjustments can cause card jams. ( Note: While positive settings help stop jamming.
Adjustments affect flash and smudge.)
3.7.16 Using the Resin Heat Adjust Setting
Use this adjustment for when the Black resin text and barcodes appear faded or too light/dark.
3.7.17 Using the Sleep Time Setting
This setting adjusts the time until the printer stops energizing the transfer roller conserving
energy. Disable is indicated with a 0 setting. (Note: The counter for this setting starts after
Standby Time has elapsed.)
3.7.18 Using the Standby Time Setting
This setting adjusts the time until the printer goes into a reduced transfer roller temperature to
conserve energy. (Note: A zero (0) setting disables. Settings are in minutes.)
3.7.19 Using the Blush Point Setting
The blush point is compensation during printing:
• There is no dye transfer.
• There is no a light gray line on a portion of the card.
• It should be white.
3.7.20 Using the LCD Contrast Setting
This setting adjusts the LCD panel brightness.
3.7.21 Using the Cleaning Rate Setting
The printer Cleaning Rate is a default of 3000 passes.