HID EDGE EVO Solo ESH400 Hi-O Controller Installation Guide - Manual

EDGE EVO is the next evolution in access control hardware solutions. A true IP solution that meets the demands of open architecture,
IP-centric environments, EDGE EVO provides fully distributed intelligence and decision making right to the door, leveraging the IT
infrastructure to the maximum extent possible. Wire the EDGE EVO device to Hi-O interface modules providing connectivity to electronic
door components and access control readers.
Hi-O involves devices with built-in intelligence and a CANbus that links all the devices together. Password protect or encrypt Hi-O CANbus
data traffic. Each Hi-O device (such as the push plate, electric strike, card reader and door operator) is connected to the CANbus by a
single, four-wire cable. Two of the wires supply power and the other two are used for data communication.
Specifications
CONDITIONS VOLTAGE DC (VDC)
CURRENT
(Amp)
Power (W)
OPERATING
TEMPERTURE
CABLE LENGTH
UL REF
NUMBER
Input
DC Input (NSC)
+12 VDC 0.14 Amp 1.68
32° - 122°F
(0° - 50° C)
Hi-O CAN Bus Total Length 100 ft (30 m) -
22 AWG ● 0.65mm ● 0.33mm 2
Maximum between drops 30 ft (10 m)
22 AWG ● 0.65mm ● 0.33mm 2
RJ45 = 328 ft (100 m) - Category 5 K
E400CX
1
X
2
N
+24 VDC 0.08 Amp 1.92
PoE (+48VDC NOM) 0.05 Amp 2.40
DC Input (MAX)
+12 VDC 1.5 Amp 18.00
+24 VDC 1.5 Amp 36.00
PoE (+48 VDC NOM) 0.3 Amp 14.40
Output
CAN DC
Output
(MAX)
AUX 12 / 24 VDC Input +10.8 to +24 VDC 1.2 Amp* 28.80
PoE Input + 24 VDC (NOM) 0.4 Amp* 9.60
NSC = Normal Standby Condition
*
Combined output ratings not to exceed V*I = W.
Values:
• 1.2 Amp (+24 VDC AUX Input, 28.80 W)
• 1.2 Amp (+12 VDC AUX Input, 12.46 W)
• 0.4 Amp (PoE Input, 9.6 W)
EDGE EVO ®
Hi-O Networked Controller
EH400 / ESH400
I
nstallatIon
G
uIde
82000-920, Rev D.1
October 2012
© 2009 - 2012 HID Global Corporation. All rights reserved.
15370 Barranca Parkway
Irvine, CA 92618-2215
USA
X
1
= K for Black
G for Gray
X
2
= N for non-Solo
S for Solo