HID HDPii Plus User Guide 2.0 - Manual (Page 42)

HDP5000 & HDPii Card Printer Encoder User Guide_L000950, 2.0
Page 42 of 103 December 2012
© 2012 HID Global Corporation. All rights reserved
3.9.8 Using the Use Substitute Panel Data
Only ribbons with the F or I panel have this option available in the driver.
When selecting Split Mode in the driver and the Flipper Module is present, the first page of the
document is printed to the front of the card with the YMC ribbon panel. Following, the second
page is printed on the front of the card with the F ribbon panel. Lastly, the third page is printed on
the back with the K ribbon panel.
When Split Mode is not selected and the Flipper Module is present, the first page of the
document is printed to the front of the card with the YMC ribbon panel. Following, the second
page is printed on the front of the card with the F ribbon panel. The third page is printed on the
back of the card with the YMC ribbon panel. Lastly, the fourth page is printed on the back of the
card with the F ribbon panel.
When enabling Use Substitute Panel Data - displayed is the following details.
3.9.8.1 YMCFK Ribbon
Split Ribbon ON (Duplex)
Page 1 is YMC on the front, Page 2 is F on the front, Page 3 is K on the back. WB entry and “~”
commands ignored.
Split Ribbon OFF (Duplex)
Page 1 is YMC on the front, Page 2 is F on the front, Page 3 is YMC on the back, Page 4 is F on
the back. WB entry and “~” commands ignored.
Split Ribbon OFF (Simplex)
Page 1 is YMCK on the front, Page 2 is F on the front. WB entry and “~” commands ignored.