Method 2: using digi devices, Hardware: attach device to digi, Drivers: connect devices to your network – Vaisala viewLinc 4.3 User Manual
Page 20
Connecting Devices
12
4
|
4
M211679EN-A
Repeat Steps 1 and 2 for each vNet Device.
Method 2: Using Digi Devices
The following procedure shows how to use Digi Devices to connect
your Vaisala Veriteq Devices to the network.
Hardware: Attach Device to Digi
1
Connect your Vaisala Veriteq Device to a Digi Device using a
Vaisala Veriteq cable.
2
Connect your Digi Device to power supply and Ethernet outlet.
Note: These instructions focus on the Digi One SP. For other
Digi models, see
Drivers: Connect Devices to your Network
This section describes how to install the drivers for Digi Devices to
connect Vaisala Veriteq Devices or Vaisala 300 Series Transmitters
to the network using an Ethernet connection. Repeat all of these
steps for each Digi Device you’ll use.