HP Officejet Pro 8500A - Manual (Page 79)

3. Touch down arrow , and then select Tone or Pulse Dialing.
4. Touch to select Tone Dialing or Pulse Dialing.
Set the redial options
If the printer was unable to send a fax because the receiving fax machine did not
answer or was busy, the printer attempts to redial based on the settings for the busy-
redial and no-answer-redial options. Use the following procedure to turn the options on
or off.
• Busy redial: If this option is turned on, the printer redials automatically if it
receives a busy signal. The factory-set default for this option is ON.
• No answer redial: If this option is turned on, the printer redials automatically if the
receiving fax machine does not answer. The factory-set default for this option is OFF.
To set the redial options
1. Touch right arrow , and then select Setup.
2. Touch Fax Setup, and then select Advanced Fax Setup.
3. TouchBusy Redial or No Answer Redial, and then select the appropriate options.
Set the fax speed
You can set the fax speed used to communicate between your printer and other fax
machines when sending and receiving faxes.
If you use one of the following, setting the fax speed to a slower speed might be
required:
• An Internet phone service
• A PBX system
• Fax over Internet Protocol (FoIP)
• An integrated services digital network (ISDN) service
If you experience problems sending and receiving faxes, try using a lower Fax Speed.
The following table provides the available fax speed settings.
Fax speed setting Fax speed
Fast v.34 (33600 baud)
Medium v.17 (14400 baud)
Slow v.29 (9600 baud)
To set the fax speed
1. Touchright arrow , and then select Setup.
2. Touch Fax Setup, and then touch Advanced Fax Setup.
3. Touch Fax Speed.
4. Touch to select an option.
Change fax settings 75