HP Secure Key Manager - Manual (Page 239)

LDAP Administrator Server Properties section
Use the LDAP Administrator Server Properties section to define the basic properties of the LDAP
administrator directory server.
Figure 132 Viewing LDAP Administrator Server Properties section
Table 113 LDAP Administrator Server Properties section components
Description Component
The hostname or IP address of the primary LDAP server. Hostname or IP Address
The port on which the LDAP server is listening. LDAP servers typically use port 389. Port
By default the SKM appliance connects directly to the LDAP server over TCP. Check
this box to use SSL between the device and the LDAP server.
Use SSL
Select a Trusted Certificate Authority to use to verify that server certificates
presented by LDAP servers are signed by a CA trusted by the SKM appliance. This
option is valid only if you use SSL to communicate with the LDAP server.
Trusted Certificate Author-
ity
The number of seconds to wait for the LDAP server during connections and searches
before timing out. If the connection times out, the authorization fails.
Timeout (sec)
The distinguished name (DN) to be used to bind to the server. The device will bind
using these credentials to perform searches for users and groups. If your LDAP
server supports anonymous searches, you may leave this field and the Bind Pass-
word field empty.
Bind DN
The password to be used to bind to the LDAP server. Bind Password
Click to modify the properties. Edit
Click to remove the current properties Clear
Click to test the LDAP connection after you have defined an LDAP server. LDAP Test
LDAP Schema Properties
The LDAP Schema Properties section describes the schema for your LDAP administrator directory.
Secure Key Manager 239