HP Secure Key Manager - Manual (Page 147)

Description Component
Click Edit to modify the properties. Edit
Click Clear to remove the current properties. Clear
LDAP Failover Server Properties
Use the LDAP Failover Server Properties section to define a backup LDAP server to use in case the
main LDAP server becomes inaccessible due to a non-timeout error. When the primary LDAP server
is down, the SKM shifts to the failover LDAP server and periodically retry the main server to see if it
has become accessible again.
Figure 72 Viewing the LDAP Failover Server Properties section
The following table describes the components of the LDAP Failover Server Properties section.
Table 53 LDAP Failover Server Properties section components
Description Component
The IP address or hostname of the LDAP server to use as the failover.
Failover Server IP or
Hostname
The port on which the LDAP server is listening. Failover Server Port
Click Edit to modify the properties. Edit
Click Clear to remove the current properties. Clear
Click LDAP Test to test the LDAP connection after you have defined an LDAP server. LDAP Test
TIP:
The Testing the LDAP User Directory Connection and Testing the LDAP Failover Server Connection
commands are basically equivalent to the LDAP Test buttons in the Management Console; however,
they print connection information as well and thus can be more helpful in debugging connection
problems.
LDAP User & Group Configuration
The LDAP User & Group Configuration page enables you to view the users and groups for the KMS
Server as defined by the LDAP directory. You can only view the users and groups on this page; users
and groups are created, modified, and removed on the LDAP server itself.
This page contains the following sections:
• LDAP Users
• LDAP Groups
Secure Key Manager 147