HP StorageWorks XP Remote Web Console Software - Manual (Page 82)

• Serial Number: Serial number of the connected array
• IP Address: IP address of the connected array (SVP)
• Main FW Version: Version of the microcode installed in the connected array
• SVP Version: Version of the XP Remote Web Console Java applet program installed in the SVP of
the connected array
• RMI Server Version: Version of the RMI server installed in the SVP of the connected array
Port Status
Port Status information is shown on the right side of the System panel.
Figure 54 Port Status
.
Port Status provides information about the ports.
Cluster-1 and Cluster-2 indicate the clusters. The Cluster-1 ports are listed on the upper section of the
panel, and the Cluster-2 ports are listed on the lower section.
Each cluster has eight PCBs (printed circuit boards) and the name of each PCB is displayed on the
header of the port list. The icons show the port name, port LED status, and equipment information.
The icons indicate the following information:
•
: This port is equipped, and the cable is properly set. It is currently in use and available for
the operation.
•
: This port is equipped and available for the operation.
•
: This port is not equipped or not available.
XP Remote Web Console Main Panel, Status Tab
The Status panel shows detailed information on the internal status of the connected array, including
the service information message (SIM) that is being reported to the host. There are five SIM severity
levels: good, service, moderate, serious, and acute (see
Table 13 ).
Performing XP Remote Web Console Operations 82